Setting of door and tailgate unlock function (Except for vehicles equipped
with
a Dead Lock System)
The door and tailgate unlock function can be set to the following two conditions.
Each time the door and tailgate unlock function is set, a chime will sound to tell you the condition of the door and tailgate unlock function.
1. Remove the key from the ignition switch.
2. Place the combination headlamps and dipper switch in the “OFF” position, and
leave the driver’s door open.
3. Press and hold the LOCK switch (1) for 4 to 10 seconds and then also press
the UNLOCK switch (2) during this time.
4. Release in sequence the LOCK and UNLOCK switches within 10 seconds of pressing
the LOCK switch in step 3.
NOTE
• On vehicles equipped with MITSUBISHI Multi-Communication System (MMCS), screen operations can be used to make the adjustment.
Refer to the separate owner’s manual for details.
See also:
Dipper (High/Low beam change)
When the lamp switch is in the position,
the beam changes from high to low (or low to high) each time the lever is pulled
fully (1). While the high beam is on, the high-beam indication lamp in th ...
To adjust forward or backward
Lift the seat adjusting lever and adjust the seat forward or backward to the
desired position. After adjustment, release the adjusting lever to lock the seat
in position.
WARNING
To ensure the ...
System preparation mode (approx. 20 seconds)
(The buzzer sounds intermittently and the security indicator (A) blinks.)
The system preparation time extends from the point at which all of the doors
and rear hatch are locked by pressing the LO ...