Setting the system
Follow the procedure below to set the system to the system armed mode.
1. Except for vehicles equipped with the keyless operation system, remove the key from the ignition switch. For vehicles equipped with the keyless operation system, put the operation mode in OFF.
2. Exit the vehicle and close all of the doors, tailgate and bonnet.
3. Press the LOCK switch (A) on the remote control switch of the keyless entry system or the keyless operation system, the driver’s or front passenger’s door lock/unlock switch (B), or the tailgate LOCK switch (C) in order to lock all the doors and the tailgate.
By locking the vehicle using the keyless entry system or the keyless operation function, the system preparation mode is activated.
The buzzer makes an intermittent beeping sound and the security indicator (D) in the audio panel blinks for confirmation.
NOTE
• The system preparation mode is not activated when the doors and the tailgate have been locked using a method other than the keyless entry system or the keyless operation function (namely a key, the inside lock knob or the central door lock switch).
• If the bonnet is open, the security indicator illuminates, and the system does not enter the system preparation mode.
When the bonnet is closed, the system enters the system preparation mode, and after approximately 20 seconds the system enters the system armed mode.
4. After approximately 20 seconds, the buzzer stops, and when the blinking of the security indicator starts to slow down, the system armed mode goes into effect.
The security indicator continues to blink during the system armed mode.
NOTE
• The security alarm system can be activated when people are riding inside the vehicle or when the windows are open. To prevent accidental activation of the alarm, do not set the system to the system armed mode while people are riding in the vehicle.
• Avoid leaving valuable items inside the vehicle even when the security alarm system has been set to the “active” mode.
To deactivate the vehicle inclination detection function and the interior intrusion detection function
The vehicle inclination detection function and the interior intrusion detection function can be deactivated when parking in automated car parks, when leaving pets in the vehicle or when leaving the vehicle with the windows slightly open.
1. Except for vehicles equipped with the keyless operation system, remove the key from the ignition switch. For vehicles equipped with the keyless operation system, put the operation mode in OFF.
2. Raise and hold the wiper and washer switch to the “MIST” position for approximately 3 seconds. The buzzer will sound once and the function will be deactivated.
To activate the function again, raise and hold the wiper and washer switch to the “MIST” position for approximately 3 seconds.
The buzzer will sound twice and the function will be activated.
NOTE
• The function will be activated again if the following operation is performed.
• If the doors and the tailgate are unlocked using the keyless entry system or
the keyless operation function.
• If the ignition switch is turned to the “ON” or “ACC” position (except for
vehicles equipped with the keyless operation system).
• If the operation mode is put in ON or ACC (vehicles with the keyless operation
system).
See also:
Electronic immobilizer (Antitheft starting system)
[For vehicles equipped with keyless operation system]
For information on operations for vehicles equipped with the keyless operation
system, refer to “Keyless operation system: Electronic immobil ...
Charge warning display
If there is a fault with the charging system, the warning display is displayed
on the information screen in the multi-information display. The warning lamp in
the instrument cluster also illumin ...
Function setting screen
The “Display language”, “Temperature unit”, “Fuel consumption unit”, and “Average
fuel consumption and speed reset method” etc. settings can be modified as desired.
Refer to “Ch ...