Alarm activationAlarm activation - Security alarm system - Locking and unlocking - Mitsubishi ASX Owner's Manual - Mitsubishi ASX

When the system is in the system armed mode, the alarm will be activated as follows if the vehicle is unlocked or if any of the doors, tailgate or bonnet is opened using a method other than the keyless entry system or the keyless operation function.

1. The alarm will be activated for approximately 30 seconds. The turn-signal lamps will blink, and the siren will sound intermittently.

2. The alarm will resume if unlawful actions are taken again, even if the alarm

2. The alarm will resume if unlawful actions are taken again, even if the alarm has stopped.

• During an alarm operation, the alarm is displayed on the information screen NOTE

• During an alarm operation, the alarm is displayed on the information screen in the multiinformation display.

Type 1

Type 2

Type 2

Cancelling the alarm

    See also:

    To unlock
    Press the UNLOCK switch (2). All the doors and the tailgate will be unlocked. If the doors and tailgate are unlocked when the front room lamp switch is in the “DOOR” position or the rear room ...

    To check the fluid level
    The fluid level must be between the “MAX” and “MIN” marks on the reservoir. The fluid level is monitored by a float. When the brake fluid level falls below the “MIN” mark, the brake f ...

    Steering wheel height adjustment
    To adjust the steering wheel height, release the tilt lock lever while holding the steering wheel by hand, and raise or lower the steering wheel to the desired height. After adjustment, securel ...