Electric window control
The electric windows can only be operated with the ignition switch in the “ON” position or the operation mode in ON.
WARNING
• Before operating the electric window control, make sure that nothing can
get trapped (head, hand, finger, etc.).
• Never leave the vehicle without removing the key.
• Never leave a child (or other person who might not be capable of safe operation
of the electric window control) in the vehicle alone.
• The child may tamper with the switch at the risk of its hands or head being
trapped in the window.
Electric window control switch
Each door window opens or closes while the corresponding switch is operated.
1- Driver’s door window
2- Front passenger’s door window
3- Rear left door window
4- Rear right door window
5- Lock switch
Driver’s switches
The switches can be used to operate all door windows.
A window can be opened or closed by operating the corresponding switch.
Press the switch down to open the window, and pull up the switch to close it.
If the switch for the driver’s window is fully pressed down/pulled up, the door window automatically opens/closes completely.
If you want to stop the window movement, operate the switch lightly in the reverse direction.
Passenger’s switches
The passenger’s switches can be used to operate the corresponding passenger’s door windows. Press the switch down for opening the window, and pull up the switch for closing it.
NOTE
• Repeated operation with the engine stopped will run down the battery. Operate the electric window switches only while the engine is running.
• The rear door windows only open halfway.
Lock switch
When this switch is operated, the passenger’s switches cannot be used to open or close the door windows and the driver’s switch cannot open or close any door windows other than the driver’s window.
To unlock, press it once again.
1- Lock
2- Unlock
WARNING
• A child may tamper with the switch at the risk of its hands or head being trapped in the window. When driving with a child in the vehicle, please press the window lock switch to disable the passenger’s switches.
Timer function
The door windows can be opened or closed for 30 seconds after the engine is stopped.
However, once the driver’s door or the front passenger’s door is opened, the windows cannot be operated.
Safety mechanism (driver’s door window only)
If a hand or head is trapped in the closing window, it will lower automatically.
Nonetheless, make sure that nobody puts their head or hand out of the window when closing the driver’s door window.
The lowered window will become operational after a few seconds.
WARNING
• If the safety mechanism is activated three or more times successively, the safety mechanism will be temporarily cancelled.
If a hand or head got trapped, a serious injury could result.
CAUTION
• The safety mechanism is cancelled just before the window is fully closed. This allows the window to close completely.
Therefore be especially careful that no fingers are trapped in the window.
• The safety mechanism is deactivated while the switch is pulled up. Therefore be especially careful that fingers are not trapped in the door window opening.
NOTE
• The safety mechanism can be activated if the driving conditions or other circumstances cause the driver’s door window to be subjected to a physical shock similar to that caused by a trapped hand or head.
• If the safety mechanism is activated three or more times in a row, the safety mechanism will be cancelled and the door window will not close correctly.
In such a case, the following procedure should be implemented to rectify this situation.
If the window is open, repeatedly raise the driver’s door window switch until the window has been fully closed. Following this, release the switch, raise the switch once again and hold it in this condition for at least 1 second, then release it. You should now be able to operate the driver’s door window in the normal fashion.
See also:
Electronic immobilizer (Antitheft starting system)
[For vehicles equipped with keyless operation system] For information on operations
for vehicles equipped with the keyless operation system, refer to “Keyless operation
system: Electronic immobi ...
iPod control panel and display
1- AM/FM button
2- CD (Mode change) button
3- PWR (On-Off) button
4- PAGE (Title scroll) button
5- DISP (Title display) button
6- RPT (Repeat) button
7- RDM (Random) button
8- (Fast-revers ...
Position lamps (except for vehicles equipped with high intensity discharge headlamps)
1. For petrol-powered vehicles equipped with turbocharger, when replacing the
bulb on the left side, remove the bolt (A) holding down the relay box and move the
relay box towards the rear of the v ...