Seat belt inspectionSeat belt inspection  - Seat and seat belts - Mitsubishi ASX Owner's Manual - Mitsubishi ASX

• Check the belts for cuts, worn or frayed webbing and for cracked or deformed metallic parts. Replace the belt assembly if it is defective.

• A dirty belt should be cleaned with neutral detergent in warm water. After rinsing in water, let it dry in the shade. Do not attempt to bleach or re-dye the belts because this will affect their characteristics.

• We recommend you to have all seat belt assemblies including retractors and WARNING

• We recommend you to have all seat belt assemblies including retractors and attaching hardware inspected after any collision.

We recommend that seat belt assemblies in use during a collision be replaced unless the collision was minor and the belts show no damage and continue to operate properly.

• Do not attempt to repair or replace any part of the seat belt assemblies; we recommend you to have this work done by a MITSUBISHI MOTORS Authorized Service Point. Incorrect repair or replacement could reduce the effectiveness of the belts and could result in serious injury in the event of a collision.

• Once the pretensioner has been activated, it cannot be re-used.

It must be replaced together with the retractor.

    See also:

    Obstacle detection areas
    The detection areas of the corner and back sensors are limited to those shown in the illustration. Moreover, the sensors are unable to detect low or thin objects or objects near the rear bumper. T ...

    Driver’s and front passenger’s airbag system
    The driver’s airbag is located under the padded cover in the middle of the steering wheel. The front passenger’s airbag is contained in the instrument panel above the glove box. The driver’ ...

    Accessory socket
    The accessory socket can be used while the ignition switch is in the “ON” or “ACC” position. Caution ► Be aware that using electronic equipment with the engine off may run the bat ...