Average speed displayAverage speed display - Multi-information display - Instruments and controls - Mitsubishi ASX Owner's Manual - Mitsubishi ASX

This displays the average speed from the last reset to the present time.

There are the following 2 mode settings.

For the method for changing the average speed display setting, refer to “Changing the function settings (when the ignition switch or the operation mode is ON)”.

Manual reset mode

Manual reset mode

• When the average speed is being displayed, if you hold down the multi-information meter switch, the average speed displayed at that time is reset.

• When the following operation is performed, the mode setting is automatically switched from manual to auto.

[Except for vehicles equipped with keyless operation system]

Turn the ignition switch from the “ACC” or “LOCK” position to the “ON” position.

[For vehicles equipped with keyless operation system]

Change the operation mode from ACC or OFF to ON.

Switching to auto occurs automatically. If switching to manual mode is done, however, the data from the last reset is displayed.

Auto reset mode

• When the average speed is being displayed, if you hold down the multi-information meter switch, the average speed displayed at that time is reset.

• When the engine switch or the operation mode is in the following conditions, the average speed display is automatically reset.

[Except for vehicles equipped with keyless operation system]

The ignition switch is in the “ACC” or “LOCK” position for about 4 hours or longer.

[For vehicles equipped with keyless operation system]

The operation mode is in ACC or OFF for about 4 hours or longer.

• The average speed display and the average fuel consumption display can be reset NOTE

• The average speed display and the average fuel consumption display can be reset individually for the auto reset mode and manual reset mode.

• “---” is displayed when the average speed cannot be measured.

• The initial (default) setting is “Auto reset mode”.

• The display setting can be changed to the preferred units (km/h or mph).

Refer to “Changing the function settings (when the ignition switch or the operation mode is ON)”.

• The memory of the auto reset mode or manual reset mode for the average speed display is erased if the battery is disconnected.

    See also:

    Headlamp levelling switch
    The angle of the headlamp beam varies depending upon the load carried by the vehicle. The headlamp levelling switch can be used to adjust the headlamp illumination distance (when the lower beam ...

    Position lamps (for vehicles equipped with high intensity discharge headlamps)
    1. To create enough work space, turn the steering wheel all the way in the direction opposite to the side you wish to replace. 2. Remove the clips (A) and screws (B) to turn up the cover (C). ...

    Accessory socket
    The accessory socket can be used while the ignition switch is in the “ON” or “ACC” position. Caution ► Be aware that using electronic equipment with the engine off may run the bat ...