Manual mode
The manual adjustment mode is also available in case the “Auto mode” shows the incorrect time when the adjacent local RDS stations are located in a different time zone.
For manual time adjustment, use the procedure below:
1. Switch off the audio once by pressing the PWR switch (1).
2. While pressing
the CH4 button (2), press the PWR switch (1) until it beeps. The “CT” display (A)
disappears and this is the “Manual adjustment mode”.
3. Set the time by pressing
the various buttons as described below.
H - To adjust the hour
M - To adjust the minutes
SET- To reset the minutes
to zero
10:30 - 11:29 ... Changes to 11:00
11:30 - 12:29 ... Changes to 12:00
See also:
Starting the engine (petrol-powered vehicles)
The starting procedure is as follows: 1. Fasten the seat belt.
2. Make sure the parking brake is applied.
3. Depress and hold the brake pedal.
4. Fully depress the clutch pedal. (M/T)
Note
υ ...
Changing the function settings (when the ignition switch is “ON”)
1. Stop the vehicle in a safe place.
Firmly apply the parking brake and put the gearshift lever into the “N” (Neutral)
position (M/T), the selector lever into the “P” (PARK) position (CVT) ...
Rear–centre three–point seat belt
The rear–centre three–point seat belt must be worn correctly as shown in the
illustration.
1. Pull the seat belt and fit tongue (A) into the black buckle (C). 2. Push
tongue (B) firmly in ...
