Average fuel consumption

This value shows the average fuel consumption (in L/100 km or mpg) since the display was reset. If you reset the display at the time when you want to start the measurements, average fuel consumption from that point of time can be displayed.
To reset the display
[Vehicles without MITSUBISHI genuine audio]
Push the button (A) for more than 2 seconds.
![[Vehicles with MITSUBISHI genuine audio]](images/books/119/2/page.h65.jpg)
[Vehicles with MITSUBISHI genuine audio]
Push the “DISP” button for more than 2 seconds.
NOTE
(1) When the ignition switch is turned on, the average fuel consumption which
was being displayed when the ignition switch was previously turned off will be displayed
once again.
(2) Average fuel consumption varies according to the conditions under
which a vehicle is travelling (road conditions, the manner in which the vehicle
is being driven, etc.). Observe this display for reference because the fuel consumption
display may differ from the actual fuel consumption.

See also:
Service reminder
This displays the distance and number of months until the next periodic inspection.
Refer to “Service reminder”. ...
How the supplemental restraint system works
The SRS includes the following components:
1- Air bag module (Driver) 2- Air bag module (Passenger) 3- Air bag control
unit (including the front impact sensor) 4- Seat belt pre-tensioner
5- Si ...
Air purifier
An air filter has been incorporated into this air conditioning so that dirt and
dust are cleaned from the air.
Replace the air filter periodically as its ability to clean the air will be reduced
...
