To install
Align the tyre valve with the valve opening provided on the wheel cover.
Then tap around the outer edge of the wheel cover with your hand to secure it in place.
NOTE
Full wheel covers have a symbol mark provided on the reverse side to show the air valve location.
Before installing the wheel cover to the wheel, make sure that the opening with the symbol mark is correctly aligned with the air valve.
See also:
Selector positions
P - PARK
This position locks the transmission to prevent the vehicle from moving. The
engine can be started in this position.
R - REVERSE
Move the lever to this position only after the vehicle ha ...
Flooded engine
If the engine has become flooded during starting, first operate the starter for
5 to 6 seconds while fully depressing the accelerator pedal, then start the engine
without depressing the accelerato ...
Brake fluid
Check the brake fluid level in the reservoir. The brake fluid level must be between
the “MAX” and “MIN” marks on the reservoir. The fluid level falls slightly with
wear of the brake pads ...