Selection of engine oil (petrol-powered vehicle)
(1) Select engine oil of the proper SAE viscosity number according to the atmospheric
temperature. For 0W-30, 5W-30, 0W-40 and 5W-40 viscosity grade, use only ACEA A3
classification.
(2) Use engine oil conforming to the following classification:
- ACEA classification: “For service A1, A2 or A3”
- API classification: “FOR SERVICE SG” or higher
NOTE
Use of additives is not recommended since they may reduce the effectiveness of additives already included in the engine oil. It may result in failure of the mechanical assembly.
See also:
Manual mode
The manual mode is also available in case the automatic mode shows the incorrect
time when the adjacent local RDS stations are located in a different time zone.
Refer to “Radio data system (RDS) ...
Keyless operation key take-out monitoring system
Type 1
Type 2
When the vehicle is parked with the ignition switch in any position other than
“LOCK” (PUSH OFF), if you close the door after opening any of the doors and taking
the keyles ...
Warning lamp
The ABS warning lamp should illuminate when the ignition switch is turned ”ON”,
and should go off in a few seconds.
CAUTION
If the warning lamp stays on or does not illuminate when you start ...