To lockTo lock  - Keyless entry system - Locking and unlocking - Mitsubishi Lancer Owner's Manual - Mitsubishi Lancer

Press the LOCK switch (1). All the doors and rear hatch will be locked. The turn-signal lamps will blink once.

► With a vehicle that has a Dead Lock System, pressing the LOCK switch (1) two Note

► With a vehicle that has a Dead Lock System, pressing the LOCK switch (1) two times in succession causes the Dead Lock System to be set. (Refer to “Setting the system”.)

    See also:

    Braking
    All the parts of the brake system are critical to safety. Have the vehicle serviced by an authorized MITSUBISHI dealer at regular intervals according to the service booklet. Brake system (1) The ...

    Front passenger seat belt warning lamp
    The front passenger seat belt warning lamp is located on the instrument panel. The lamp comes on when a person sits on the front passenger seat but does not fasten the seat belt. It goes off when ...

    Engine coolant
    To check the coolant level A transparent coolant reserve tank (A) is located in the engine compartment. The coolant level in this tank should be kept between the “LOW” and “FULL” marks whe ...