Testing the system
Open all of the door windows, then set the Dead Lock System. (Refer to “Setting the system”.) After setting the Dead Lock System, reach into the vehicle through a window and confirm that you cannot unlock the doors using the lock knobs.
Note
► If you need advice on how to set the Dead Lock System, please contact a MITSUBISHI MOTORS Authorized Service Point.
See also:
Changing the security alarm settings
It is possible to set the security alarm to the “active” mode or “inactive” mode.
Follow the procedure below.
1. Turn the ignition switch to the “LOCK” position.
If you started the engi ...
Tips for starting
► Do not operate the starter motor continuously longer than 10 seconds; doing
so could run down the battery. If the engine does not start, turn the ignition switch
back to “LOCK”, wait a ...
Operating range for starting the engine
The operating range is the interior of the vehicle.
: Forward direction
: Operating range
Note
► Even if it is within the operating range, if the keyless operation key is in
a small i ...
