Pretensioner systemPretensioner system  - Seat belt pretensioner system and force limiter system - Seat and seat belts - Mitsubishi Lancer Owner's Manual - Mitsubishi Lancer

The pretensioner system will retract their respective seat belts instantaneously, thus maximizing the seat belt’s effectiveness, if there is a frontal impact severe enough to injure the driver and/or front passenger and the ignition switch is in the “ON” or “START” position.

► To obtain the best results from your pretensioner seat belt, make sure you Warning

► To obtain the best results from your pretensioner seat belt, make sure you have adjusted your seat correctly and wear your seat belt properly.

► Installation of audio equipment or repairs in the vicinity of the pretensioner Caution

► Installation of audio equipment or repairs in the vicinity of the pretensioner seat belts or floor console must be performed in line with MITSUBISHI MOTORS guidelines. It is important to do so because the work could affect the pretensioner systems.
► If you need to scrap the vehicle, please consult a MITSUBISHI MOTORS Authorized Service Point. It is important to do so because unexpected activation of the pretensioner seat belts could cause injuries.

► The pretensioner seat belts will be activated if the vehicle suffers a severe Note

► The pretensioner seat belts will be activated if the vehicle suffers a severe frontal impact, even if the seat belts are not worn.
► The pretensioner seat belts are designed to work only once. After the pretensioner seat belts have been activated, we recommend you have it replaced by a MITSUBISHI MOTORS Authorized Service Point.

    See also:

    Door ajar warning display screen (when the ignition switch is “OFF”)
    If any of the doors or the rear hatch is not completely closed, this displays the open door or rear hatch. 1- Doors and rear hatch are closed 2- Doors or rear hatch is open ...

    Auto mode
    (MITSUBISHI genuine audio only) The automatic adjustment mode can set the local time automatically by using the signal from the local RDS stations. In this mode, “CT” (A) (Clock Time: sent with ...

    Changing the security alarm settings
    It is possible to set the security alarm to the “active” mode or “inactive” mode. Follow the procedure below. 1. Turn the ignition switch to the “LOCK” position. If you started the engi ...