Installing a child restraint system to a 3-point type seat belt (with emergency locking mechanism)Installing a child restraint system to a 3-point type seat belt (with emergency 
locking mechanism)  - Child restraint - Seat and seat belts - Mitsubishi Lancer Owner's Manual - Mitsubishi Lancer

Installation:

Installation:

1. Fasten the seat belt to secure the child restraint system. Make sure you hear a “click” when you insert the latch plate in the buckle.
2. Remove all slack by using the locking clip.
3. Push and pull the child restraint in all directions to be sure it is secure.

► For some types of child restraint, the locking clip (A) should be used to Warning

► For some types of child restraint, the locking clip (A) should be used to help avoid personal injury during a collision or sudden manoeuvre.
It must be fitted and used in accordance with the child restraint manufacturer’s instructions.
The locking clip must be removed when the child restraint is removed.

Seat belt inspection

    See also:

    Except for vehicles equipped with rain sensor
    The windscreen wiper and washer can be operated with the ignition switch in the “ON” or “ACC” position. If the blades are frozen to the windscreen, do not operate the wipers until the ice ...

    If the DPF warning display and check engine warning lamp illuminate at the same time during vehicle operation
    If an abnormal condition occurs in the DPF system, the DPF warning display and check engine warning lamp illuminate. Have the system inspected at a MITSUBISHI MOTORS Authorized Service Point. ...

    Cancelling the system
    The following methods can be used to cancel the system when it is in the system preparation mode or the system armed mode. ► Pressing the UNLOCK switch on the remote control switch. ► ...