Mark display screen (when the ignition switch is “ON”)Mark display screen (when the ignition switch is “ON”) - Multi-information display - Instruments and controls - Mitsubishi Lancer Owner's Manual - Mitsubishi Lancer

Mitsubishi Lancer / Mitsubishi Lancer Owner's Manual / Instruments and controls / Multi-information display / Mark display screen (when the ignition switch is “ON”)

This is displayed when you press the multi- information meter switch and switch

This is displayed when you press the multi- information meter switch and switch the warning display screen.

This mark is also displayed if there is another warning other than the one displayed.

When the cause of the warning display is eliminated, the Note mark goes out automatically.

► When the mark is displayed, the Note

► When the warning display screen can be redisplayed on the information screen. mark is displayed, the warning display screen can be redisplayed on the information screen.
Refer to “Information screen (when the ignition switch is “OFF“)”.
Refer to “Information screen (when the ignition switch is “ON”)”.

    See also:

    How to repeat the same track
    You can repeatedly listen to the same track by pressing the RPT button (10). Press the RPT button, and the RPT indicator (15) will come on. To release, press the button again. How to use the SCAN b ...

    Curtain airbag system
    The curtain airbags are contained in the front and rear pillars and roof side rail. The curtain airbag is designed to inflate only on the side of the vehicle that is impacted, even with no passeng ...

    Changing the security alarm settings
    It is possible to set the security alarm to the “active” mode or “inactive” mode. Follow the procedure below. 1. Turn the ignition switch to the “LOCK” position. If you started the engi ...