ParkingParking  - Operation of the Twin Clutch SST - Twin Clutch SST (Sport Shift Transmission) - Starting and driving - Mitsubishi Lancer Owner's Manual - Mitsubishi Lancer

To park the vehicle, first bring it to a complete stop, fully engage the parking brake, and then move the gearshift lever to the “P” (PARK) position.

If you are going to leave the vehicle unattended, always switch off the engine and carry the key.

► On a slope, be sure to apply the parking brake before moving the gearshift Note

► On a slope, be sure to apply the parking brake before moving the gearshift lever to the “P” (PARK) position. If you move the gearshift lever to the “P” (PARK) position before applying the parking brake, it may be difficult to disengage the gearshift lever from the “P” (PARK) position when you next drive the vehicle, requiring application of a strong force to the gearshift lever to move from the “P” (PARK) position.

    See also:

    Operating the system in automatic mode
    In normal conditions, use the system in the AUTO mode and follow these procedures: 1. Set the blower speed selection dial to the “AUTO” position. 2. Set the temperature control dial to the de ...

    Adjustable seat belt anchor (front seats)
    The seat belt anchor height can be adjusted. Move the seat belt anchor up or down with the lock knob (A) depressed. CAUTION When adjusting the seat belt anchor, set it at a position that is suff ...

    Tips for starting
    ► Do not operate the starter motor continuously longer than 10 seconds; doing so could run down the battery. If the engine does not start, turn the ignition switch back to “LOCK”, wait a ...