To resume the set speedTo resume the set speed  - Cruise control - Starting and driving - Mitsubishi Lancer Owner's Manual - Mitsubishi Lancer

If the set speed driving is deactivated by the condition described in “To deactivate”, you can resume the previously set speed by pressing the “ACC RES” switch (C) while driving at a speed of about 40 km/h (25 mph) or higher.

Under either of the following conditions, however, using the switch does not

Under either of the following conditions, however, using the switch does not allow you to resume the previously set speed.

In these situations, repeat the speed setting procedure:

► The “ON OFF” switch is pressed.
► The ignition switch is turned OFF.
► “CRUISE” indication lamp is turned OFF.

    See also:

    To temporarily increase or decrease the speed
    To temporarily increase the speed Depress the accelerator pedal as you would normally. When you release the pedal, you will return to your set speed. Note ► In some driving conditions, th ...

    Leg area heating
    Set the mode selection dial to the position shown in the illustration and set the air selection switch (A) to the outside position. Adjust the temperature by turning the temperature control dial ...

    Driving range display
    This displays the approximate driving range (how many more kilometres or miles you can drive). When the driving range falls below approximately 50 km (30 miles), “---” is displayed. Refuel as ...