Corner and back sensor locations
There are two corner sensors (A) at the corners of the rear bumper, and two back sensors (B) in the centre of the rear bumper.
See also:
To change a tyre
1. On vehicles equipped with wheel covers, first remove the covers (refer to
“Wheel covers”). Then loosen the wheel nuts a quarter turn with the
wheel nut wrench. Do not remove the wheel nuts ...
The security alarm has four modes
System preparation mode (approx. 20 seconds)
(The buzzer sounds intermittently and the security indicator (A) blinks.)
The system preparation time extends from the point at which all of the doors ...
Roof drip moulding
When installing the roof carrier, remove the roof drip moulding caps.
1. Open the cover (A) and remove the screws using a Philips screwdriver. 2.
Remove the caps by sliding them.
After removal o ...