Obstacle detection areasObstacle detection areas  - Reversing sensor system - Starting and driving - Mitsubishi Lancer Owner's Manual - Mitsubishi Lancer

The detection areas of the corner and back sensors are limited to those shown in the illustration. Moreover, the sensors are unable to detect low or thin objects or objects near the rear bumper. Thus, make sure to check the surroundings as you operate the vehicle in a safe manner.

See also:

Engine coolant
A translucent coolant reserve tank is located in the engine compartment. The coolant level in this tank should be kept between the two marks on the reserve tank when measured while the engine is ...

Supplemental restraint system (SRS) - air bag
The information written in this supplemental restraint system (SRS) section contains important points concerning the driver, front passenger, side air bags and pre-tensioner seat belts. The SRS a ...

Front room & map lamps
When replacing the bulb, put the front room & map lamps switch into the “OFF” position. 1. Insert a straight blade (or minus) screwdriver with a cloth over its tip into the notch of the l ...