Reversing sensor system warning display
In case there is a malfunction in the reversing sensor system, the display for the malfunctioning sensor will blink and the warning buzzer will sound for approximately 5 seconds. Even after the buzzer has stopped sounding, the display will continue blinking until the system reverts to the normal state. Have the vehicle inspected at a MITSUBISHI MOTORS Authorized Service Point.

See also:
To turn an airbag off
WARNING
• To reduce risk of serious or fatal injury:
• Always remove the key from the ignition switch before operating a front passenger’s
airbag ON-OFF switch.
Failure to do so could adve ...
Passenger compartment (LHD vehicles)
The fuse blocks in the passenger compartment are located behind the fuse lid
in front of the driver’s seat at the position shown in the illustration.
A- Main fuse block
B- Sub fuse block
1. O ...
Multi centre display
When the ignition switch is in the ”ACC” position, the outside temperature and
clock are displayed in the multi centre display. When the ignition switch is in
the ”ON” position, the aver ...
