To adjust the toneTo adjust the tone  - LW/MW/FM digital tuning radio with CD changer - For pleasant driving - Mitsubishi Lancer Owner's Manual - Mitsubishi Lancer

Press the SOUND switch (4) to select: SUB PUNCH → TYPE → FIELD → BASS → MID → TREBLE → FADER → BALANCE → audio control mode OFF.

► The SUB LEVEL can only be adjusted on vehicles equipped with a premium sound Note

► The SUB LEVEL can only be adjusted on vehicles equipped with a premium sound system.
On vehicles without a premium sound system, when you press the SOUND switch (4), the display starts from TYPE.

QUICK ACCESS MODE

To access the sound customization features quickly, push and hold the SOUND switch (4), then turn the switch clockwise or anticlockwise to access your desired sound customization setting. Release the switch to adjust the setting.

HOLD MODE

If the SOUND switch (4) is pushed and held for more than 2 seconds during the audio adjust mode, it will change to “Hold” mode. The selected audio mode will be held until the SOUND switch (4) is pushed for more than 2 seconds again.

SUB PUNCH (Subwoofer volume control)

To select the desired subwoofer volume level.

TYPE (Acoustic characteristic selection)

1. Turn the SOUND switch (4) to select the desired music type.
2. Press the SOUND switch (4) to set the audio system to the selected music type.

FIELD (Sound field selection)

FIELD (Sound field selection)

1. Turn the SOUND switch (4) to select the desired sound field.
2. Press the SOUND switch (4) to set the audio system to the selected sound field.

BASS (Bass tone control)

BASS (Bass tone control)

Turn the SOUND switch (4) to select the desired bass tone.

MID (Midrange tone control)

Turn the SOUND switch (4) to select the desired middle tone.

TREBLE (Treble tone control)

Turn the SOUND switch (4) to select the desired treble tone.

FADER (Front/Rear balance control)

Turn the SOUND switch (4) to balance volume from the front and rear speakers.

BALANCE (Left/Right balance control)

Turn the SOUND switch (4) to balance volume from the left and right speakers.

► When set to 0, it will beep. Note

► When set to 0, it will beep.
► When SUB PUNCH, TYPE or FIELD is changed, the sound will cut out briefly, but this does not indicate a malfunction.
► The audio control mode will shut off if either the radio or CD is operated, or if no adjustment is made within about 10 seconds.

    See also:

    2010 Mitsubishi Outlander Review
    While Mitsubishi's Outlander got a whole new front-end look for 2010, what it really needed was a remake of its base four-cylinder engine, which is weak and doesn't get good gas mileage, either. ...

    Auto reset mode
    ► When the average fuel consumption is being displayed, if you hold down the multi-information meter switch, the average fuel consumption displayed at that time is reset. ► If the ign ...

    To add coolant
    The cooling system is a closed system and normally the loss of coolant should be very slight. A noticeable drop in the coolant level could indicate leakage. If this occurs, we recommend you to have ...