Fog lamp switchFog lamp switch  - Instruments and controls - Mitsubishi Lancer Owner's Manual - Mitsubishi Lancer

See also:

Introduction of outside air
To introduce air into the vehicle during hot weather, set the air selection switch (A) to the outside position and set the temperature control dial to the position shown in the illustration. Be ...

Starting the engine (petrol-powered vehicles)
The starting procedure is as follows: 1. Fasten the seat belt. 2. Make sure the parking brake is applied. 3. Depress and hold the brake pedal. 4. Fully depress the clutch pedal. (M/T) Note υ ...

Headlamps (low beam, except for vehicles with high intensity discharge headlamps)
1. For petrol-powered vehicles equipped with turbocharger, when replacing the bulb on the left side, remove the bolt (A) holding down the relay box and move the relay box towards the rear of the v ...