Cancelling the alarmCancelling the alarm  - Security alarm system - Locking and unlocking - Mitsubishi ASX Owner's Manual - Mitsubishi ASX

It is possible to halt the activation of an alarm using the following methods:

• Pressing the LOCK or UNLOCK switch on the remote control switch.

(After pressing the LOCK switch, the vehicle will lock if all the doors and the tailgate are closed, after which the system preparation mode will once again go into effect.)

Wybierz odmiany do wysiewu https://wujeknasionko.pl/.

• Turning the ignition switch to the “ON” position (except for vehicles equipped with the keyless operation system).

• Putting the operation mode in ON (vehicles equipped with the keyless operation system).

• Holding the keyless operation key and locking and unlocking the doors and the tailgate using the keyless operation function (vehicles equipped with the keyless operation system).

• When the ignition switch is turned to the “ON” position or the operation mode NOTE

• When the ignition switch is turned to the “ON” position or the operation mode is put in ON, the buzzer sounds 4 times. This operation indicates that the alarm was activated while the vehicle was parked.

Please check the inside of the vehicle to confirm that nothing was stolen.

• Even if the battery is disconnected, the alarm activation memory will not be erased.

    See also:

    How the supplemental restraint system works
    The SRS includes the following components: 1- Air bag module (Driver) 2- Air bag module (Passenger) 3- Air bag control unit (including the front impact sensor) 4- Seat belt pre-tensioner 5- Si ...

    For the front seat
    The cup holder is located in front of the floor console. Type 1 Type 2 To use the cup holder, open the lid. ...

    Ride Quality & Noise
    When you're not having fun tossing this car around, you're really not having fun. The ride is harsher than an all-wheel-drive Lancer we tested without the sports suspension; rough roads jostle the ...