Sunroof*

The sunroof can only be operated with the ignition switch in the “ON” position.
To open
Press the switch (1) to open the sunroof. The sunroof stops once before the sunroof
is fully opened. Re–press the switch (1) to open completely.
To stop the moving
sunroof, press the switch (2).
To close
The sunroof automatically closes if the switch (2) is pressed.
To stop the
moving sunroof, press the rear of the switch (1).
To tilt up
When the switch (3) is pressed, the rear sunroof raises approximately 35 mm for ventilation.
NOTE
Before tilting the sunroof, completely open the sunshade. Otherwise you will not have good ventilation.
To close
Press the switch (4).
See also:
Operating the system in automatic mode
In normal conditions, use the system in the AUTO mode and follow these procedures:
1. Set the blower speed selection dial to the “AUTO” position.
2. Set the temperature control dial to the de ...
Using the MIVEC engine
The MIVEC engine automatically controls valve timing in accordance with driving
conditions for maximum engine performance.
Note
► To protect the engine, the high-speed mode may not be selec ...
Outlander in the Market
The small-crossover segment is one of the most contested corners of the
automotive world right now, with new and improved models continuously attempting
to one-up each other. Against this kind of ...
