Filling the fuel tankFilling the fuel tank - General information - Mitsubishi Lancer Owner's Manual - Mitsubishi Lancer

► When handling fuel, comply with the safety regulations displayed by garages Warning

► When handling fuel, comply with the safety regulations displayed by garages and filling stations.
► Before removing the fuel cap, be sure to get rid of your body’s static electricity by touching a metal part of the car or the fuel pump. Any static electricity on your body could create a spark that ignites fuel vapour.
► Perform the whole refueling process (opening the fuel tank filler door, removing the fuel cap, etc.) by yourself. Do not let any other person come near the fuel tank filler. If you allowed a person to help you and that person was carrying static electricity, fuel vapour could be ignited.
► Do not move away from the fuel tank filler until refueling is finished. If you moved away and did something else (for example, cleaning your windscreen) partway through the refueling process, you could pick up a fresh charge of static electricity.
► If the tank cap must be replaced, use only a MITSUBISHI MOTORS original part.

Fuel tank capacity

2WD: 59 litres
4WD: 55 litres

Refueling

1. Before filling with fuel, stop the engine.
2. The fuel tank filler is located on the rear left side of your vehicle.

Open the fuel tank filler door by pulling the release lever located on the side of the driver’s seat.

3. Open the fuel tank filler tube by slowly turning the cap anticlockwise.

3. Open the fuel tank filler tube by slowly turning the cap anticlockwise.

A- Remove

A- Remove
B- Close

► Since the fuel system may be under pressure, remove the fuel tank filler Caution

► Since the fuel system may be under pressure, remove the fuel tank filler tube cap slowly. This relieves any pressure or vacuum that might have built up in the fuel tank. If you hear a hissing sound, wait until it stops before removing the cap. Otherwise, fuel may spray out, injuring you or others.

4. While filling with fuel, store the cap in the capholder located on the inside of the fuel tank filler door.

5. Insert the gun in the tank port as far as it goes.

5. Insert the gun in the tank port as far as it goes.

► Do not tilt the gun. Caution

► Do not tilt the gun.

6. When the gun stops automatically, do not fill with fuel any more.
7. To close, turn the fuel tank filler tube cap slowly clockwise until you hear clicking sounds, then gently push the fuel tank filler door closed.

    See also:

    Retracting and extending the mirrors using the mirror retractor switch
    With the ignition switch in the “ON” or “ACC” position, push the mirror retractor switch to retract the mirrors. Push it again to extend the mirrors to their original positions. After pla ...

    Card holder
    Cards can be slipped into the holder (A) on the back of the sun visor. ...

    Multi centre display
    When the ignition switch is in the ”ACC” position, the outside temperature and clock are displayed in the multi centre display. When the ignition switch is in the ”ON” position, the aver ...