Installation of accessoriesInstallation of accessories  - General information - Mitsubishi Lancer Owner's Manual - Mitsubishi Lancer

We recommend you to consult a MITSUBISHI MOTORS Authorized Service Point.

► The installation of accessories, optional parts, should only be carried out within the limits prescribed by law in your country, and in accordance with the guidelines fitting instructions and warnings contained within the documents accompanying the parts or accessories.

► Improper installation of electrical components may cause an electrical fire if incorrectly fitted. Please refer to the section “Modification/ alterations to the electrical or fuel systems” within this owner’s manual.

► Using a cellular phone or radio set inside the vehicle without an external antenna may cause electrical system interference, which could lead to unsafe vehicle operation.

► Tyres and wheels which do not meet specifications must not be used.

Refer to the “Specifications” section for information regarding wheel and tyre sizes.

Important points!

Due to large number of accessory and replacement parts of different manufactures available in the market, it is not possible, not only for MITSUBISHI MOTORS, but also for a MITSUBISHI MOTORS Authorized Service Point, to check whether the attachment or installation of such parts affects the overall safety of your MITSUBISHI-vehicle.

Even when such parts are officially authorized, for example by a “general operators permit” (an appraisal for the part) or through the execution of the part in an officially approved manner of construction, or when a single operation permit following the attachment or installation of such parts, it cannot be deduced from that alone, that the driving safety of your vehicle has not been affected.

Consider also that there basically exists no liability on the part of the appraiser or the official. Only in the case of parts (MITSUBISHI MOTORS original replacement or exchange parts as well as MITSUBISHI MOTORS genuine accessories) that are recommended and released by a MITSUBISHI MOTORS Authorized Service Point and that are attached or installed by a MITSUBISHI MOTORS Authorized Service Point, you can assume that optimal safety has been provided. The same also pertains to modifications of MITSUBISHI vehicles with respect to the production specifications. For your own safety, in such cases, you should only undertake modifications according to the recommendations of a MITSUBISHI MOTORS Authorized Service Point.

    See also:

    Outside rear-view mirrors
    To adjust the mirror position The outside rear-view mirrors can be operated when the ignition switch or the operation mode is in ON or ACC. WARNING • Do not attempt to adjust the rear-view mir ...

    Position lamps (except for vehicles equipped with high intensity discharge headlamps)
    1. For petrol-powered vehicles equipped with turbocharger, when replacing the bulb on the left side, remove the bolt (A) holding down the relay box and move the relay box towards the rear of the v ...

    Rheostat (meter illumination control)
    The rheostat can be adjusted while the lamp switch is “” or “”. Turn the dial to adjust the meter illumination to the desired brightness. 1- To increase brightness 2- To reduce brightne ...