Instruments and controls
► When the ignition switch is switched from “ACC” or “LOCK” to “ON”, the mode setting is automatically switched from manual to auto.
Switching to auto occurs automatically. If switching to manual mode is done, however, the data from the last reset is displayed.
See also:
Outside rear-view mirror
On the driver’s seat side, a compound curved-surface mirror is used, while on
the front passenger’s seat side, a single curvedsurface mirror is used.
The compound curved-surface mirror has di ...
Vehicle labeling
Vehicle identification number
The vehicle identification number is stamped on the bulkhead as shown in the
illustration.
Vehicle information code plate
The vehicle information code plate is riv ...
Starting
Tips for starting
• Do not operate the starter motor continuously longer than 10 seconds; doing
so could run down the battery. If the engine does not start, turn the ignition switch
back to “ ...