Changing the time until “REST REMINDER” is displayed
The time until the display appears can be changed.
1. Press and hold the multi-information meter switch for about 2 seconds or more to switch from the setting mode screen to the menu screen.
Refer to “Changing the function settings (when the ignition switch is “ON”)”.
2. Lightly press the multi-information meter switch to select “ALARM” (rest time setting).

3. Press and hold the multi-information meter switch for about 2 seconds or more to display “ALARM” (rest time setting).

4. Lightly press the multi-information meter switch to select the time until
the display.
5. Press and hold the multi-information meter switch for about 2 seconds or more,
the setting is changed to the selected time.
Note
► If the battery is disconnected, the unit setting is erased from memory and
is automatically set to OFF.
► The drive time is reset when the ignition switch is turned off.
See also:
Average speed
For vehicles with MITSUBISHI genuine audio, average speed can be displayed. This
value shows the average speed (in km/h or mph) since the display was reset. If you
reset the display at the time ...
How to enter PTYs in the memory
As many as 6 PTYs can be entered in the memory.
Follow the steps described below.
1. Press either the TUNE/SEEK button (5 or 6) to tune the PTY to be entered in
the memory. 2. Press one of the mem ...
How to enter frequencies in the memory
Manual setting
You can assign to the memory select buttons (8) a maximum of 12 stations in the
UKW band (6 U1 stations and 6 U2 stations), 6 stations in the MW band and 6 stations
in the LW ban ...
