Lamp monitor buzzerLamp monitor buzzer - Combination headlamps and dipper switch - Instruments and controls - Mitsubishi Lancer Owner's Manual - Mitsubishi Lancer

[When the engine was started using the key] If the driver’s door is opened when the key is in the “LOCK” or “ACC” position or removed from the ignition switch while the lamps are on, a buzzer will sound to remind the driver to turn off the lamps.

[When the engine was started using the keyless operation function] If, while the lamps are illuminated, the ignition switch is set to the “LOCK” or “ACC” position, or the driver’s door is opened with the ignition switch set to the “LOCK” position, a buzzer will sound to remind the driver to turn off the lamps.

In both cases, the buzzer will automatically stop if the auto-cutoff function is activated, the lamp switch is turned off, or the door is closed.

    See also:

    AWC control fluid
    To check the fluid level The AWC control fluid reservoir is in the luggage compartment. Note ► Check the fluid level in the reservoir 90 minutes or more after turning the ignition switch t ...

    High–mounted stop lamp
    Hatchback Place the groove of clip top as shown, then remove the cover. Undo bolts (A), remove the lamp body, and disconnect the connector. Undo screws (B) and take the bulb out of its socket ...

    Wiper blade rubber replacement
    If the blades are frozen to the windscreen or rear window, do not operate the wipers until the ice has melted and the blades are freed, otherwise the wiper motor may be damaged. Windscreen wiper ...