Hazard warning flasher switchHazard warning flasher switch  - Instruments and controls - Mitsubishi Lancer Owner's Manual - Mitsubishi Lancer

Use the hazard warning flasher switch when the vehicle has to be parked on the road for any emergency.

The hazard warning flashers can always be operated, regardless of the position of the ignition switch.

Push the switch to turn on the hazard warning flashers, all turn-signal lamps flash continuously. To turn them off, push the switch again.

Note

► While the hazard warning lamps are blinking due to having manually pushed the Note

► While the hazard warning lamps are blinking due to having manually pushed the switch, the emergency stop signal system does not operate.
Refer to “Emergency stop signal system”.

    See also:

    Installing a child restraint system to a3-point type seat belt (with emergency locking mechanism)
    3-point type seat belt location The child restraint system can be fitted by using the 3-point type seat belt at the below illustrated seating position. Installation: 1. Fasten the seat belt to ...

    Front fog lamps (Type 1)
    1. Remove the screw (A) and pull the cover out. 2. Remove the screws (B) and pull the entire lamp unit out. Note ► When unfastening the screws, be careful not to mistakenly move the beam ...

    Indication and warning lamp list
    1- Position lamp indication lamp ® 2- High-beam indication lamp ® 3- Charge warning lamp ® 4- Turn-signal indication lamps/Hazard warning indication lamps ® 5- Front fog lamp indication lamp ...