To adjust the mirror positionTo adjust the mirror position - Outside rear-view mirrors - Starting and driving - Mitsubishi Lancer Owner's Manual - Mitsubishi Lancer

The outside rear-view mirrors can be operated when the ignition switch is in the “ON” or “ACC” position.

► Do not attempt to adjust the rear-view mirrors while driving. This can be Warning

► Do not attempt to adjust the rear-view mirrors while driving. This can be dangerous.
Always adjust the mirrors before driving.
► Your vehicle is equipped with convex type mirrors. Please take into consideration, that objects you see in the mirror will look smaller and farther away compared to a normal flat mirror.
Do not use this mirror to estimate distance of following vehicles when changing lanes.

1. Place the lever (A) to the same side as the mirror whose adjustment is desired.

L- Left outside mirror adjustment

L- Left outside mirror adjustment
R- Right outside mirror adjustment

2. Press the switch (B) to the left, right, up or down to adjust the mirror position.

1- Up
2- Down
3- Right
4- Left

3. Return the lever (A) back to the middle position Retracting and extending the outside mirrors

    See also:

    Twin Clutch SST control mode
    Select the control mode from the following two types to suit the driving conditions. Note ► When continuously driving on closed circuit tracks or at other locations where the engine is op ...

    To check the coolant level
    A transparent coolant reserve tank (A) is located in the engine compartment. The coolant level in this tank should be kept between the “LOW” and “FULL” marks when measured while the engine ...

    On a bumpy or rutted road
    Drive as slow as possible when driving on bumpy or rutted roads. Caution ► The impact on tyres and/or wheels when driving on a bumpy or rutted road can damage the tyre and/or wheel. ► ...