To operateTo operate  - Hill start assist (vehicles with Twin Clutch SST) - Starting and driving - Mitsubishi Lancer Owner's Manual - Mitsubishi Lancer

1. Stop the vehicle completely using the brake pedal.
2. Release the brake pedal and the hill start assist will maintain the braking force applied while stopping for approximately 2 seconds.
3. Depress the accelerator pedal and the hill start assist gradually will decrease the braking force as the vehicle starts moving.

Öffne die Seite für feminisierte samen hier.

► The hill start assist is activated when all of the following conditions are Note

► The hill start assist is activated when all of the following conditions are met.
• The engine is running.
(The hill start assist will not be activated while the engine is starting or immediately after the engine is started.)
• The gearshift lever is in any position other than “P” (PARK) or “N” (NEUTRAL).
• The vehicle is completely stationary, with the brake pedal depressed.
• The parking brake is released.
► The hill start assist will not operate if the accelerator pedal is depressed before the brake pedal is released.
► The hill start assist also operates when reversing on an uphill slope.

    See also:

    Windscreen washer
    The windscreen washer can be operated with the ignition switch in the “ON” or “ACC” position. The washer fluid will be sprayed onto the windscreen by pulling the lever towards you. When ...

    Loading a roof carrier
    Caution ► Use a roof carrier that properly fits your vehicle. Do not load luggage directly onto the roof. For installation, refer to the instruction manual accompanying the roof carrier. N ...

    Engine compartment fuse location table
    1: Except for petrol-powered vehicles equipped with turbocharger 2: Petrol-powered vehicles with turbocharger 3: Fusible link 1: Except for petrol-powered vehicles equipped with turbochar ...