To use the external audio input functionTo use the external audio input function - For pleasant driving - Mitsubishi Lancer Owner's Manual - Mitsubishi Lancer

Mitsubishi Lancer / Mitsubishi Lancer Owner's Manual / For pleasant driving / To use the external audio input function

Auxiliary Audio connector (RCA)

Auxiliary Audio connector (RCA)
A- Left audio input connector (white)
B- Right audio input connector (red)

Auxiliary Video connector (RCA)
A- Left audio input connector (white)
B- Right audio input connector (red)
C- Video input connector (yellow)

You can listen to commercially available audio equipment, such as a portable audio system, from your vehicle’s speakers, by connecting the audio equipment to the audio input connectors, which are external input connectors (pin jacks).

► On vehicles equipped with the MITSUBISHI Multi-Communication System (MMCS), Note

► On vehicles equipped with the MITSUBISHI Multi-Communication System (MMCS), refer to the separate owner’s manual of the MITSUBISHI Multi-Communication System.

To activate the external audio input mode

1. Use a commercially available audio cable to connect the audio equipment to

1. Use a commercially available audio cable to connect the audio equipment to the external audio input connector.

2. Press the CD button (D) for more than 2 seconds.

The display (E) will show “AUX” and then the external audio input mode will be activated.

3. To deactivate the external audio input mode, press the AM/FM button (F) or the CD button (D) to switch to another mode.

► Do not operate the connected audio equipment while driving. Caution

► Do not operate the connected audio equipment while driving.
This could distract you and an accident might occur.

► The connected audio equipment cannot be operated with the vehicle’s audio system. Note

► The connected audio equipment cannot be operated with the vehicle’s audio system.
► Depending on the connected audio equipment, it may produce noise from the speakers.
► Use the connected audio equipment’s own power source, such as its battery.
Noise may be produced from the speakers if the connected audio equipment is used while charging it using the accessory socket of the vehicle.
► Do not activate the external audio input mode when no audio equipment is connected.
Otherwise, noise may be produced from the speakers.
► Connect audio equipment when the external audio input mode is deactivated or lower the vehicle’s speaker volume before connecting it.
Noise may be produced from the speakers if audio equipment is connected after the external audio input mode is activated.
► For information on how to connect and operate the audio equipment, refer to the owner’s manual for the equipment.

    See also:

    Jacking up 4-wheel drive vehicles
    Warning ► Do not crank the engine while jacking up the vehicle. The tyre on the ground may turn and the vehicle may roll off the jack. ...

    Child restraint
    When transporting children in your vehicle, some type of child restraint system should always be used according to the size of the child. This is required by law in most countries. The regulation ...

    Lamps (headlamps, fog lamp, etc.) auto-cutout function
    • If the following operation is performed while the lamp switch is in the position, the lamps will automatically go out when the driver’s door is opened. [Except for vehicles equipped with ke ...