Operation of the Dead Lock SystemOperation of the Dead Lock System - To operate using the keyless operation function - Keyless operation system - Locking and unlocking - Mitsubishi Lancer Owner's Manual - Mitsubishi Lancer

With a vehicle that has a Dead Lock System, it is possible to set the Dead Lock System using the driver’s or front passenger’s door lock/unlock switch, or the rear hatch LOCK switch. (Refer to “Dead Lock System”.)

    See also:

    Leg area heating
    Set the mode selection dial to the position shown in the illustration and set the air selection switch (A) to the outside position. Adjust the temperature by turning the temperature control dial ...

    Tips for starting
    (1) Do not operate the starter motor continuously for anything longer than 10 seconds; doing so could run down the battery. If the engine does not start, turn the ignition switch back to “LOCK ...

    To reduce the set speed
    There are 2 ways to reduce the set speed. Auto–speed control lever Pull down and hold the auto–speed control lever until you reach the lower speed you want. Release the lever when the desire ...