Cancelling the system
When the following operation is performed, the doors and rear hatch will unlock and the Dead Lock System will be simultaneously cancelled.
► The UNLOCK switch (D) on the remote control switch is pressed.
► The driver’s or front passenger’s door lock/ unlock switch (B) is pressed while you are carrying the keyless operation key.
► The rear hatch OPEN switch (E) is pressed.
Note
► If neither a door nor rear hatch is opened within 30 seconds of unlocking (except for using the rear hatch OPEN switch), the doors and rear hatch are automatically relocked and the Dead Lock System is simultaneously set again.
► Even when it is not possible to use the keyless entry system or the keyless operation function to unlock the doors, it is possible to use the key to unlock the driver’s door.
When the key is used to unlock the driver’s door, the Dead Lock System is cancelled for only the driver’s door. If you wish to subsequently unlock all other doors, turn the ignition switch to the “ON” or “ACC” position.
► It is possible to adjust the time between pressing the UNLOCK switch (D) on the remote control switch or the driver’s or front passenger’s door lock/unlock switch (B) and automatic locking. For details, please contact a MITSUBISHI MOTORS Authorized Service Point.
On vehicles equipped with MITSUBISHI Multi-Communication System (MMCS), screen operations can be used to make the adjustment.
Refer to the separate owner’s manual for details.
► It is possible to lock the doors and rear hatch and set the Dead Lock System at the same time with a single push of the LOCK switch (A) on the remote control switch, the driver’s or front passenger’s door lock/unlock switch (B), or the rear hatch LOCK switch (C). For details, please contact a MITSUBISHI MOTORS Authorized Service Point.
See also:
Cleaning the sunroof
Clean the inside of the sunroof with a soft cloth.
Hard deposits should be wiped away with a cloth dipped in warm, neutral detergent
solution. Wipe away the solution with a sponge dipped in fresh w ...
Instruments and controls
► When the ignition switch is switched from “ACC” or “LOCK” to “ON”, the mode
setting is automatically switched from manual to auto.
Switching to auto occurs automatically. If swi ...
Passenger compartment (LHD vehicles)
The fuse blocks in the passenger compartment are located behind the fuse lid
in front of the driver’s seat at the position shown in the illustration.
A- Main fuse block
B- Sub fuse block
1. O ...