Alarm activation
The turn-signal lamps blink and the siren sounds for approximately 30 seconds. Refer to “Alarm activation”.
Note
► The alarm will resume if unlawful actions are taken again, even if the alarm has stopped.
See also:
Tips for starting
► Do not operate the starter motor continuously longer than 10 seconds; doing
so could run down the battery. If the engine does not start, turn the ignition switch
back to “LOCK”, wait a ...
To change the language of PTY display
You can select your favourite language between English, French, German, Swedish,
Spanish and Italian.
1. Turn off the radio. 2. Turn the radio back on while holding down the PTY
button (B). 3. An ...
Check engine warning lamp
This lamp is a part of an onboard diagnostic system which monitors the emissions,
engine control system or CVT control system/Twin Clutch SST control system.
If a problem is detected in one of th ...