Cancelling the systemCancelling the system - Security alarm system - Locking and unlocking - Mitsubishi Lancer Owner's Manual - Mitsubishi Lancer

The following methods can be used to cancel the system when it is in the system preparation mode or the system armed mode.

► Pressing the UNLOCK switch on the remote control switch.
► Turning the ignition switch to the “ON” position.
► Opening any of the doors or the rear hatch, or inserting the key into the ignition switch when the system is in the system preparation mode.
► Holding the keyless operation key and pressing the driver’s and front passenger’s door lock/unlock switch, or the rear hatch OPEN switch to unlock the doors and rear hatch (vehicles with the keyless operation system).

► If the bonnet is opened during the system preparation mode, the system preparation Note

► If the bonnet is opened during the system preparation mode, the system preparation mode is suspended.
The system returns to the system preparation mode when the bonnet is closed.
► If the battery terminals are disconnected while the system is in the system preparation mode, the memory will be erased.
► It is possible to register up to 8 remote control switches for the keyless entry system and 4 remote control switches for the keyless operation system.
As long as they are registered, any of the remote control switches, other than the one used to activate the system, can be used to cancel the system.
If you want to register additional remote control switches, please contact a MITSUBISHI MOTORS Authorized Service Point.
► The activation distance for the keyless entry system is approximately 4 m.
If it is not possible to lock or unlock the vehicle by pressing the switch at the correct distance or the security alarm system cannot be set or cancelled using the switch, the battery may need to be replaced.
Replace the battery at a MITSUBISHI MOTORS Authorized Service Point.
► If the UNLOCK switch on the remote control switch, or the driver’s or front passenger’s door lock/unlock switch is pressed and no door or the rear hatch is opened within 30 seconds, the doors or the rear hatch will automatically relock. In this case as well, the system preparation mode will go into effect.
► The time between pressing the UNLOCK switch on the remote control switch, or the driver’s or front passenger’s door lock/unlock switch and automatic locking can be adjusted.
Consult a MITSUBISHI MOTORS Authorized Service Point.
On vehicles equipped with MITSUBISHI Multi-Communication System (MMCS), screen operations can be used to make the adjustment.
Refer to the separate owner’s manual for details.

    See also:

    Multi-link Rear Suspension
    The Lancer's sophisticated new trailing-arm type multi-link rear suspension is a major factor in providing ride and handling characteristics that might be expected from a more expensive vehicle. T ...

    Checking battery electrolyte level
    The electrolyte level must be between the “max” and “min” marks stamped on the outside of the battery. Replenish with distilled water as necessary. The inside of the battery is divided in ...

    Setting of door and rear hatch unlock function (vehicles equipped with the central door lock switch)
    The door and rear hatch unlock function can be set to the following two conditions. Each time the door and rear hatch unlock function is set, a chime will sound to tell you the condition of the doo ...