Cancelling the alarmCancelling the alarm - Security alarm system - Locking and unlocking - Mitsubishi Lancer Owner's Manual - Mitsubishi Lancer

It is possible to halt the activation of an alarm using the following methods: ► Pressing the LOCK or UNLOCK switch on the remote control switch.
(After pressing the LOCK switch, the vehicle will lock if all the doors and rear hatch are closed, after which the system preparation mode will once again go into effect.)
► Turning the ignition switch to the “ON” position.

► Holding the keyless operation key and locking and unlocking the doors and the rear hatch using the keyless operation function (vehicles equipped with the keyless operation system).

► When the ignition switch is turned to the “ON” position, the buzzer sounds Note

► When the ignition switch is turned to the “ON” position, the buzzer sounds 4 times.
This operation indicates that the alarm was activated while the vehicle was parked.
Please check the inside of the vehicle to confirm that nothing was stolen.
► Even if the battery is disconnected, the alarm activation memory will not be erased.

    See also:

    Sunshade
    Slide the sunshade manually to open and close it. Caution ► Be careful that hands are not trapped when closing the sunshade. Note ► Be sure to tilt down the sunroof before closing ...

    Driver’s knee airbag system
    The driver’s knee airbag is located under the steering wheel. The driver’s knee airbag is designed to deploy at the same time as the driver’s front airbag. ...

    ABS warning lamp/display
    Warning lamp If there is a malfunction in the system, the ABS warning lamp will come on and the warning display will appear on the information screen in the multi-information display. Under ...