Installing a child restraint system to the lower anchorage (ISOFIX child restraint mountings) and tether anchorageInstalling a child restraint system to the lower anchorage (ISOFIX child restraint mountings) and tether anchorage - Child restraint - Seat and seat belts - Mitsubishi Lancer Owner's Manual - Mitsubishi Lancer

Mitsubishi Lancer / Mitsubishi Lancer Owner's Manual / Seat and seat belts / Child restraint / Installing a child restraint system to the lower anchorage (ISOFIX child restraint mountings) and tether anchorage

See also:

“ASC OFF” switch
The ASC is automatically activated when the ignition switch is turned to the “ON” position. You can deactivate the system by pressing down the “ASC OFF” switch for 3 seconds or longer. Wh ...

To remove the spare tyre
1. Lift up the board. 2. To remove the spare tyre, remove the installation clamp (A) by turning it anticlockwise. Note ► Put the spare wheel under the vehicle body near the jack. This make ...

Manual transmission
The shift pattern is shown on the gearshift lever knob. During start-up, fully depress the clutch pedal and shift into 1st gear or “R” (Reverse) position. Then gradually release the clutch peda ...