Service reminderService reminder - Multi-information display - Instruments and controls - Mitsubishi Lancer Owner's Manual - Mitsubishi Lancer

Displays the approximate time until the next periodic inspection that MITSUBISHI MOTORS recommends.

“---” is displayed when the inspection time has arrived.

► Depending on the vehicle specifications, the displayed time until the next Note

► Depending on the vehicle specifications, the displayed time until the next periodic inspection may differ from that recommended by MITSUBISHI MOTORS.
In addition, the display settings for the next periodic inspection time can be modified.
To modify the display settings, have it adjusted at a MITSUBISHI MOTORS Authorized Service Point.
For more details, consult a MITSUBISHI MOTORS Authorized Service Point.

1. Displays the time until the next periodic inspection.

1. Displays the time until the next periodic inspection.

► The distance is shown in units of 100 km (100 miles). The time is shown in Note

► The distance is shown in units of 100 km (100 miles). The time is shown in units of months.

2. This informs you that a periodic inspection is due. We recommend you to consult a MITSUBISHI MOTORS Authorized Service Point.

At that time, when the ignition switch is switched from “OFF” to “ON”, the warning display is displayed for a few seconds on the information screen.

3. After your vehicle is inspected at a MITSUBISHI MOTORS Authorized Service

3. After your vehicle is inspected at a MITSUBISHI MOTORS Authorized Service Point, it displays the time until the next periodic inspection.

To reset

The “---” display can be reset while the ignition switch is “OFF”. When the display is reset, the time until the next periodic inspection is displayed and the warning display is no longer displayed when the ignition switch is switched from “OFF” to “ON”.

1. When you lightly press the multi-information meter switch a few times, the information screen switches to the service reminder display screen.

2. Press and hold the multi-information meter switch for about 2 seconds or more

2. Press and hold the multi-information meter switch for about 2 seconds or more to display is no operation for about 10 seconds with flashing, the display returns to the previous and make it flash. (If there is no operation for about 10 seconds with flashing, the display returns to the previous screen.)

3. Lightly press the multi-information meter switch while the icon is flashing to change the display from “---” to “CLEAR”. After this, the time until the next periodic inspection will be displayed.

Caution

► The customer is responsible for making sure that periodic inspection and Caution

► The customer is responsible for making sure that periodic inspection and maintenance are performed. Inspections and maintenance must be performed to prevent accidents and malfunctions.

► “---” display cannot be reset when the ignition switch is “ON”. Note

► “---” display cannot be reset when the ignition switch is “ON”.
► When “---” is displayed, after a certain distance and a certain period of time, the display is reset and the time until the next periodic inspection is displayed.
► If you accidentally reset the display, we recommend you to consult a MITSUBISHI MOTORS Authorized Service Point.

    See also:

    Rear fog lamp switch
    The rear fog lamp can be operated when the headlamps or front fog lamps (if so equipped) turn on. An indication lamp in the instrument cluster comes on when the rear fog lamp is turned on. [Vehi ...

    Average speed display
    This displays the average speed from the last reset to the present time. There are the following 2 mode settings. For the method for changing the average speed display setting, refer to “Changing ...

    To adjust seat cushion height (driver’s side only)
    Seat cushion height can be adjusted. To alter the height of the front of seat cushion 1- Raise 2- Lower To alter the height of the rear of seat cushion 3- Raise 4- Lower ...