Door ajar warning display screen (when the ignition switch is “ON”)Door ajar warning display screen (when the ignition switch is “ON”)  - Multi-information display - Instruments and controls - Mitsubishi Lancer Owner's Manual - Mitsubishi Lancer

If any of the doors or the rear hatch is not completely closed, this displays

If any of the doors or the rear hatch is not completely closed, this displays the open door or rear hatch.

If the vehicle speed exceeds approximately 8 km/h (5 mph) while a door is ajar, a buzzer sounds 4 times. This notifies the driver that a door is ajar.

► Before moving your vehicle, check that the warning lamp is OFF. Caution

► Before moving your vehicle, check that the warning lamp is OFF.

► In order to prevent the battery from running down, the lamp goes out automatically Note

► In order to prevent the battery from running down, the lamp goes out automatically if you leave the door open for a long time.

Refer to “Lamps (room lamps, etc.) auto-cutout function”.

    See also:

    Vehicle labeling
    Vehicle identification number The vehicle identification number is stamped on the bulkhead as shown in the illustration. Vehicle information code plate The vehicle information code plate is riv ...

    A/T mode changeover switch (Except for vehicles with Sports mode)
    Two drive modes, “AUTO” and “HOLD”, can be selected. Each time you press the switch, the “AUTO” and “HOLD” modes will switch alternately. When the “HOLD” mode is selected, the ...

    Twin Clutch SST control mode display screen (vehicles equipped with Twin Clutch SST)
    The operation status of the Twin Clutch SST control mode is displayed. Refer to “Twin Clutch SST control mode”. ...