Rear window wiper and washerRear window wiper and washer - Wiper and washer switch - Instruments and controls - Mitsubishi Lancer Owner's Manual - Mitsubishi Lancer

The rear window wiper and washer switch can be operated with the ignition switch in the “ON” or “ACC” position.

INT- The wiper operates continuously for several seconds then operates intermittently

INT- The wiper operates continuously for several seconds then operates intermittently at intervals of about every 8 seconds

OFF- Off

The washer fluid will be sprayed onto the rear window when the knob is turned

The washer fluid will be sprayed onto the rear window when the knob is turned fully in either direction.

The wipers operate automatically several times while the washer fluid is being sprayed.

► The rear window wiper will automatically perform several continuous operations Note

► The rear window wiper will automatically perform several continuous operations if the gearshift lever or the selector lever is put in the “R” position while the windscreen wipers or the rear window wiper is operating. (automatic operation mode)
After the automatic operation, the rear window wiper will stop operating if the knob is in the “OFF” position. If the knob is in the “INT” position, the rear window wiper will return to the intermittent operation.
It is possible to set the rear window wiper to perform the automatic operation only if the gearshift lever or the selector lever is put in the “R” position while the rear window wiper is operating with the knob in the “INT” position.
For further information, we recommend you to consult a MITSUBISHI MOTORS Authorized Service Point.
► If the knob is in the “OFF” position, turn the knob to the “INT” position twice quickly to operate the rear window wiper continuously.
(continuous operation mode)
Turn the knob to the “OFF” position to stop the rear window wiper continuous operation.

► The interval for intermittent operation can be adjusted.
For further information, we recommend you to consult a MITSUBISHI MOTORS Authorized Service Point.
On vehicles equipped with MITSUBISHI
Multi-Communication System (MMCS), screen operations can be used to make the adjustment.
Refer to the separate owner’s manual for details.

    See also:

    Caution for installing the child restraint on vehicles with a front passenger airbag
    The label shown here is attached on vehicles with a front passenger airbag. Warning ► Extreme Hazard! Do not use a rearward facing child restraint on a seat protected by an airbag in fro ...

    To remove the spare wheel
    1. Lift up the luggage floor board. 2. To remove the spare wheel, remove the installation clamp (A) by turning it anticlockwise. NOTE • Put the spare wheel under the vehicle body near the ja ...

    Changing gears
    Always use care to change the gear with the vehicle speed matched to the engine speed. Proper shifting will improve fuel economy and prolong engine life. Avoid shifting down at high speed, as this ...