Customizing the air selection (Changing function settings)Customizing the air selection (Changing function settings)  - Control panel - Heater - For pleasant driving - Mitsubishi Lancer Owner's Manual - Mitsubishi Lancer

Functions can be changed as desired, as stated below.

► Enable automatic air control:
When the heater operates, the air selection switch will be automatically controlled.

► Disable automatic air control:
Even when the heater operates, the air selection switch will not be automatically controlled.

► Setting change method Hold down the air selection switch for about 10 seconds or more.

When the setting is changed, a sound is emitted and the indication lamp flashes.

• When the setting is changed from enable to disable 3 sounds are emitted and the indication lamp flashes 3 times.
• When the setting is changed from disable to enable 2 sounds are emitted and the indication lamp flashes 3 times.

► The factory setting is “Enable automatic air control.” Note

► The factory setting is “Enable automatic air control.”
► When the mode selection dial is turned to windows the ventilator automatically switches to outside air even if “Disable automatic, in order to prevent misting of the windows the ventilator automatically switches to outside air even if “Disable automatic air control” is set.

    See also:

    Replacing tyres and wheels
    Caution ► Avoid using different size tyres from the one listed and the combined use of different types of tyres, as this can affect driving safety. Refer to “Tyres and wheels”. ► ...

    Driver’s seat belt warning lamp and display
    Warning lamp A tone and warning lamp are used to remind the driver to fasten the seat belt. If the ignition switch is turned to the “ON” position or the operation mode is put in ON while a ...

    Front passenger’s airbag OFF indication lamp
    The front passenger’s airbag OFF indication lamp is located in the instrument panel. The indication lamp normally comes on when the ignition switch is turned to the “ON” position, and goe ...