To store the flat tyre or spare wheelTo store the flat tyre or spare wheel - How to change a tyre - For emergencies - Mitsubishi Lancer Owner's Manual - Mitsubishi Lancer

1. Lift up the board.
2. To store the flat tyre or spare wheel, fit the installation clamp (A) by turning it clockwise.

Note

► On vehicles equipped with a compact spare wheel, the clamp cannot be used for Note

► On vehicles equipped with a compact spare wheel, the clamp cannot be used for a normal size tyre.

3. Have your damaged tyre repaired as soon as possible.

To store the tools and jack

Reverse the removing procedure when storing the jack, bar and wheel nut wrench. Refer to “Tools and jack”.

    See also:

    Passing acceleration
    To gain extra acceleration in “D” (DRIVE) position, push the accelerator to the floor. The Twin Clutch SST will automatically downshift. Note ► In manual shift, downshifts do not take p ...

    Rear shelf panel (Hatchback)
    To remove 1. Pull the knob and tilt the rear seat back slightly forward. 2. Slightly lift up the front edge of the rear shelf. Slide the rear shelf rearward by tapping it lightly at the right a ...

    Tips for starting
    (1) Do not operate the starter motor continuously for anything longer than 10 seconds; doing so could run down the battery. If the engine does not start, turn the ignition switch back to “LOCK ...