To lockTo lock  - Keyless entry system - Keyless operation system - Locking and unlocking - Mitsubishi Lancer Owner's Manual - Mitsubishi Lancer

Press the LOCK switch (1). All the doors and rear hatch will be locked. The turn-signal lamps will blink once.

► With a vehicle that has a Dead Lock System, pressing the LOCK switch (1) two Note

► With a vehicle that has a Dead Lock System, pressing the LOCK switch (1) two times in succession causes the Dead Lock System to be set. (Refer to “Setting the system”.)

    See also:

    Cancelling the system
    The following methods can be used to cancel the system when it is in the system preparation mode or the system armed mode. ► Pressing the UNLOCK switch on the remote control switch. ► ...

    Deployment of side air bags
    The side air bags ARE DESIGNED TO DEPLOY when... The side air bags are designed to deploy when the vehicle suffers a moderate to severe side impact to the middle of the passenger compartment. Th ...

    Changing the detection areas
    The detection areas can be changed as follows: Vehicles with a towing bar While the operation of the system is stopped at the “SONAR” switch, push the “SONAR” switch approximately 3 second ...