Manual reset modeManual reset mode  - Average speed display - Multi-information display - Instruments and controls - Mitsubishi Lancer Owner's Manual - Mitsubishi Lancer

► When the average speed is being displayed, if you hold down the multi-information meter switch, the average speed displayed at that time is reset.

► When the ignition switch is switched from “ACC” or “LOCK” to “ON”, the mode setting is automatically switched from manual to auto.

Switching to auto occurs automatically. If switching to manual mode is done, however, the data from the last reset is displayed.

    See also:

    Auto Stop & Go (AS&G) system
    The Auto Stop & Go (AS&G) system automatically stops and restarts the engine without operating the ignition switch or the engine switch when the vehicle is stopped, such as at a traffic li ...

    Radio control panel and display
    1- PWR (On-Off) switch 2- AM/FM (FM/MW/LW selection) button 3- Memory select buttons 4- TUNE switch 5- SEEK (Up-seek) button 6- SEEK (Down-seek) button 7- FM (FM1/FM2/FM3) indicator 8- ST ( ...

    Transmission
    ...