Changing the reset mode for average fuel consumption and average speed
The mode conditions for the average fuel consumption and average speed display can be switched between “Auto reset” and “Manual reset”.
1. Press and hold the multi-information meter switch for about 2 seconds or more to switch from the setting mode screen to the menu screen.
Refer to “Changing the function settings (when the ignition switch is “ON”)”.
2. Lightly press the multi-information meter switch to select “AVG (average fuel consumption and average speed setting)”.
3. Press and hold the multi-information meter switch for about 2 seconds or more to switch in sequence from A or 1 (Auto reset mode) → M, 2 or P (Manual reset mode) → A or 1 (Auto reset mode).
The setting is changed to the selected mode condition.
Manual reset mode
► When the average fuel consumption and average speed are being displayed, if
you hold down the multi-information meter switch, the average fuel consumption and
average speed displayed at that time are reset.
► When the ignition switch is switched from “ACC” or “LOCK” to “ON”, the mode setting
is automatically switched from manual to auto.
Switching to auto occurs automatically. If switching to manual mode is done, however, the data from the last reset is displayed.
Auto reset mode
► When the average fuel consumption and average speed are being displayed, if
you hold down the multi-information meter switch, the average fuel consumption and
average speed displayed at that time are reset.
► If the ignition switch is at “ACC” or “LOCK” for about 4 hours or longer, the
average fuel consumption display and average speed display are automatically reset.
Note
► The memory of the auto reset mode or manual reset mode for the average speed
display is erased if the battery is disconnected.
► The initial (default) setting is “Auto reset mode”.
See also:
Engine overheating
If the water temperature gauge indication remains in the overheating zone for
a long time, the engine may be overheating. If this occurs, take the following corrective
measures :
1. Stop the vehi ...
Hazard warning flasher switch
Use the hazard warning flasher switch when the vehicle has to be parked on the
road for any emergency.
The hazard warning flashers can always be operated, regardless of the ignition
switch positi ...
Starting the engine (petrol-powered vehicles)
The starting procedure is as follows: 1. Fasten the seat belt.
2. Make sure the parking brake is applied.
3. Depress and hold the brake pedal.
4. Fully depress the clutch pedal. (M/T)
Note
υ ...