Information screen display list
When there is information to be announced, such as lamp reminders, a sound is emitted and the screen switches to the displays shown below. Refer to the appropriate page and take the necessary measures.
When the cause of the warning display is eliminated, the warning display goes out automatically.
Note
► A warning may be displayed on the information screen and the buzzer may sound
in the following rare cases.
This is caused by the system picking up interference such as noise or strong electromagnetic
waves, and is not a functional problem.
• An extremely strong electromagnetic wave is received from a source such as an
illegal radio set, a spark from a wire, or a radar station.
• Abnormal voltage or a static electricity discharge is generated by the operation
of installed electrical equipment (including after-market parts).
If the warning display appears many times, we recommend you to consult a MITSUBISHI
MOTORS Authorized Service Point.
See also:
Brake fluid
Check the brake fluid level in the reservoir. The brake fluid level must be between
the “MAX” and “MIN” marks on the reservoir. The fluid level falls slightly with
wear of the brake pads ...
Tools, jack and tyre repair kit
Storage
The tools, jack and tyre repair kit are stowed in the luggage compartment.
The storage location of the tools, jack and tyre repair kit should be remembered
in case of an emergency.
1- T ...
To listen to the radio
1. Press the PWR switch (1) or the AM/FM button (2) to turn ON the radio.
Press the PWR switch again to turn OFF the radio.
2. Press the AM/FM button (2) to select the desired band.
3. Turn the TUN ...