If the DPF warning display illuminates during vehicle operation
Steady illumination of the DPF warning display shows that the DPF has not been able to burn away all of the trapped PM and that, as a result, an excessive amount of PM has accumulated inside it. To enable the DPF to burn away the PM, try to drive the vehicle as follows: ► With the bar graph of engine coolant temperature display stabilized in roughly the middle of the scale, drive for about 20 minutes at a speed of at least 40 km/h (25 mph).
If the DPF warning display subsequently stays on, contact a MITSUBISHI MOTORS Authorized Service Point.
Caution
► You do not have to continuously drive exactly as indicated above. Always strive to drive safely in accordance with road conditions.
See also:
Operation of the outside rear-view mirrors (Vehicles equipped with mirror retractor
switch)
To fold
Within 30 seconds of locking the doors and rear hatch using the LOCK switch (1),
press the LOCK switch twice rapidly to fold the outside rear-view mirrors.
To extend
Within 30 seconds of ...
Lamps (room lamps, etc.) auto-cutout function (Vehicles with keyless entry system
or keyless operation system)
If any of the interior lamps are left switched on with the ignition switch in
any position other than “ON” or “ACC”, it goes off automatically after approximately
30 minutes.
The lamp goe ...
To listen to the radio
1. Press the PWR switch (1) or the AM/FM button (2) to turn ON the radio.
Press the PWR switch again to turn OFF the radio.
2. Press the AM/FM button (2) to select the desired band.
3. Turn the TUN ...