Starting

See also:

Fuse replacement
1. Before replacing a fuse, always turn off the electrical circuit concerned and place the ignition switch in the “LOCK” position. 2. Remove the fuse puller (A) from the inside of the fuse box ...

Reversing sensor system detection areas
Depending on whether the vehicle is equipped with a towing bar, you can change the reversing sensor system between the standard mode and the towing bar mode. The towing bar mode changes the system ...

Front fog lamps (Type 2)
1. Remove the screw (A). 2. Pull the cover out in the direction of the arrow shown in the illustration. 3. Remove the screws (B) and pull the entire lamp unit out. Note ► When unfaste ...